Stainless steel cylinders Series 97
Single- and double-acting, cushioned, magnetic.
Ø 32, 40, 50, 63 mm
Ø 32, 40, 50, 63 mm
Series 97 stainless steel cylinders can be used in critical applications where a high level of corrosion resistance is required (for example: off-shore, naval, food industries).
These cylinders are normally equipped with end-stroke cushioning which can be adjusted through a screw on the end block.
In order to quieten the impact of the piston on the end block, these cylinders are also equipped with mechanical cushioning.
General Data
| Type of construction | The end blocks are screwed to the tube with an intermediate Teflon ring |
| Operation | Single-acting and double-acting |
| Materials | End blocks, tube, rod in stainless steel AISI 304 Rod seals in PU, piston seals in NBR Plastic guiding element, NSF H1-certified lubricant |
| Type of mounting | Threaded front and rear locking ring Pins on front cap ends Rear male hinge Articulated rear male hinge Rear female hinge |
| Stroke min-max | 25 ÷ 800 mm |
| Operating temperature | 0°C ÷ 80°C (with dry air – 20°C) |
| Operating pressure | 1 ÷ 10 bar |
| Speed | 10 ÷ 1000 mm/sec (without load) |
| Fluid | Filtered air, without lubrication. If lubricated air is used, it is recommended to use oil ISOVG32. Once applied the lubrication should never be interrupted. |
Coding Example
| 97 | M | 2 | A | 050 | A | 0200 |
| 97 | SERIES | |
| M | VERSIONS M = rear male hinge S = articulated rear male hinge F = rear female hinge T = front and rear threaded end blocks A = front end block with pin | |
| 2 | OPERATION 1 = single-acting, front spring 2 = double-acting, front and rear cushions 6 = double-acting, through-rod, front and rear cushions (T and A versions only) | PNEUMATIC SYMBOLS CS06 CD09 CD13 |
| A | MATERIALS A = stainless steel AISI 304 – PU seals V = stainless steel AISI 304 – FKM seals (150°C) | |
| 050 | BORE 032 = 32 mm 040 = 40 mm 050 = 50 mm 063 = 63 mm | |
| A | TYPE OF DESIGN A = standard (locking ring for end cap V + lock nut for rod U) | |
| 0200 | STROKE (see the table) | |
| = standard V = rod seal in FKM |
