1.5.29
- Feature extension - Support for G-Series V Digital
- Bugfix - For R-Series V Analog renamed button “Reset Setpoints” back to “Reset Factory” (it has been renamed by fault in 1.5.28)
- Feature extension - Added stroke length parsers for RF5 and RFV sensors
- Feature extension - Added indication if APP-command mode is active and Parameter tab is shown as well as when standard command mode is active and interface tab is shown.
- Update - libCOPL updated to version 4.34.1
- Feature extension - Shows progressbar on factory reset
- Bugfix - Does not show “Velocity Averages” in interface tab for R-Series V Analog FW < 1.1.9 as these do not support this feature.
- Feature extension - Support for R-Series V Analog VM
- Feature extension - Better setpoint adjustment method for G-Series V Analog
- Feature extension - Possibility to change output values at setpoints for G-Series V Analog

1.5.28
- Feature extension - Added following parameters for R-Series 5 SSI (firmware >= 2.6.4):
	1. Extrapolation Continuous Update
	2. Position Output When Unsynchronized
	3. Encoding Option “All Bits Gray”
- Feature extension - Added Demo-Mode
- Feature extension - User level passwords are stored in the web-browser.
- Feature extension - Support of G-Series V Analog
- Update - libCOPL updated to version 4.31.0
- Bugfix - Firmware update on interface boards did not work with 1.5.26
- Bugfix - Memory leak on changing user level
- Bugfix - Advanced Parameter Download uses wrong Filename
- Bugfix - Mixup of Parameters “Measurement Direction” and “Smart Missing Magnet”
- Bugfix - Leaving R-Series 5 Analog Config Mode did not work
- Bugfix - Availability of Parameter “Extra Output” for R-Series 5 SSI
- Bugfix - Scroll-up function wasn’t called for all Web-GUI buttons
- Bugfix - Issues when scanning the waveform of sensors > 3m
- Bugfix - Alignment issues when scanning waveform and threshold
- Bugfix - Download Waveform returned the unamplified waveform
- Bugfix - Authentication failed in case of some browsers communicating with TG
- Bugfix - Parameter mixup in UI: “Smart Missing Magnet” <-> “Reverse”
- Bugfix - Smart SE Firmware update returned error message even on success
- Bugfix - Supply voltage display of R-Series V sensors when > 32767mV
- Bugfix - Missing UI update of subnet and default gateway of EhternetIP sensors
- Misc Number of Magnets for Profinet and Powerlink will change the factory parameter.
- Misc Optimized texts for mobile devices
- Misc Extended limits for editing position offsets
- Misc Extended limit for editing SE length
- Misc Minor UI adjustments
